TMI industrial piping and installation

GRP / FRP safety hatches for floors and technical access

Custom-made solutions to close and protect technical openings while maintaining convenient access to structures, equipment and maintenance areas.

Custom technical access

A hatch designed around the structure into which it is integrated

In an industrial installation, an opening in a floor must remain accessible without disrupting the organization of the area. TMI manufactures polyester-composite hatches with composite frames according to project dimensions and configuration.

Custom fabrication starts from the actual opening rather than adapting a standard product afterwards. Useful dimensions, environment, access frequency and integration constraints are considered to define a solution consistent with the structure.

Any mechanical requirements or operating loads must be communicated during engineering so they can be specifically addressed according to actual site conditions.

Technical selection

The right hatch starts with a clear definition of the opening

An opening in a technical floor, industrial platform or treatment structure does not always present the same constraints. The solution must therefore be specified from the actual site configuration.

Before fabrication, dimensions, support type, environment, opening frequency and intervention requirements should be specified. This approach anticipates integration and avoids improvised adaptations on site.

  • Opening dimensions and geometry
  • Type of floor or existing support
  • Corrosive, humid or outdoor environment
  • Access frequency and maintenance requirements
  • Mechanical or operating constraints to be specified
Industrial area with technical access and GRP equipment
Integration designed for the siteThe frame, opening and operating environment are considered as a whole.
Domaines d’application

Hatches to organize and secure technical access

Custom fabrication allows GRP hatches to be integrated into different industrial structures and layouts.

01

Technical floors

Closing openings while maintaining access to networks, equipment or spaces located below floor level.

02

Water treatment

Access to chambers, technical areas and structures associated with treatment facilities where a composite solution is appropriate.

03

Industrial platforms

Integration in circulation or maintenance areas alongside grating and other technical equipment.

04

Maintenance access

Openings intended for periodic inspection and intervention on site equipment and structures.

TMI on-site work and integration of GRP equipment
From measurement to installation

Fabrication prepared around your actual configuration

Hatch quality depends not only on the material: integration with the support and structure is equally important.

01
Measurement & need

Identification of the opening, its use and the constraints of the area to be equipped.

02
Definition

Selection of hatch and frame geometry according to project data.

03
Fabrication

Manufacture of the hatch and composite frame according to validated dimensions.

04
Integration

Installation or coordination with on-site works according to the scope entrusted to TMI.

Frequently asked questions

GRP / FRP safety hatches: key points to define before fabrication

Dimensions and actual conditions of use are essential to obtain a solution suited to the structure.

What is a GRP safety hatch used for?

It closes a technical opening while maintaining access for inspection, maintenance or intervention. TMI manufactures custom polyester-composite hatches with composite frames.

Are TMI hatches custom-made?

Yes. They are defined according to opening dimensions, configuration and project constraints.

Why choose GRP / FRP for an industrial hatch?

GRP is particularly relevant where the environment presents humidity or corrosion constraints, especially alongside other composite equipment.

Can a GRP hatch be integrated into a floor or platform?

Yes. The solution can be engineered for different technical access points. Frame and hatch integration must nevertheless be defined according to the support and actual area constraints.

What information should be provided for an engineering request?

Opening dimensions, location, support type, environment, access frequency and any particular constraint help define the solution.

Installation industrielle TMI
Your technical access

Do you have an opening that needs a custom GRP hatch?

Send us the dimensions, support and constraints of your installation. TMI can engineer a solution adapted to your structure.